Version 2.0 - Legacy
Last: Vers.7.xx - 2022
- ESF Developers' Guide
- Introduction
- Getting Started
- ESF Code Examples
- Supplementary Documentation
- Resources
PART 4. Supplementary Documentation
ESF Default Configuration
· Network Interface Configuration
· Web UI Configuration Information
Overview
This section describes the default or “out of the box” configuration for ESF-enabled devices including information on default username/passwords.
List of Supported Platforms
The following platforms are currently supported by ESF version 2.0:
· ReliaGATE 50-21 (see Eurotech product page)
· DynaCOR (see Eurotech product page)
· Mini-Gateway (contact your Eurotech sales representative for more information)
· Raspberry Pi (see http://www.raspberrypi.org/)
See Installation Instructions for details on installing ESF v2 on the supported platforms.
Default Configuration
The following sections describe the default configuration for ESF on the supported hardware platforms.
Network Interface Configuration
Primary Ethernet Interface (eth0)
Enabled for LAN
Static IP Configuration
IP Address: 172.16.0.1
Netmask: 255.255.255.0
DHCP Server: yes
IP Address Range: 172.16.0.100 to 172.16.0.110
Netmask 255.255.255.0
DHCP Lease Time: 7200 minutes
NAT/Masquerade and DNS proxy: Enabled
Secondary Ethernet Interface (eth1) (second Ethernet not available on Raspberry Pi)
Enabled for WAN
Enabled as DHCP Client
Wireless 802.11 Interface (wlan0) (Wi-Fi management currently not supported in ESF on Raspberry Pi)
Enabled for LAN
Static IP Configuration
IP Address: 172.16.1.1
Netmask: 255.255.255.0
DHCP Server: yes
IP Address Range: 172.16.1.100 to 172.16.1.110
Netmask 255.255.255.0
DHCP Lease Time: 7200 mins
NAT/Masquerade and DNS proxy: Enabled
Wireless Settings
Mode: Access Point
SSID: esf_gateway
Radio Mode: 802.11 b/g
Security Mode: WPA/WPA2
Security Passphrase: testKEYS
Web UI Configuration Information
URL: http://[ip_address]
Note the “[ip_address]” is the IP Address of the device.
Default username: admin
Default password: admin